06-07-2015 10:19 PM
From diagram all PEs are 7609 except PE4 is ASR9k. When the layer 2 of PE4 loop, I found it effected to the others PEs.
PE4 configuration:
#sho run l2vpn xconnect group WiFi p2p Ii
Mon Jun 8 12:01:48.676
l2vpn
xconnect group WiFi
p2p Ii
interface TenGigE0/0/0/3.783
neighbor 10.5.80.88 pw-id 1550308814 <- PE3
PE3 configuration:
#sho run | section l2 vfi Ft manual
l2 vfi Ft manual
vpn id 783
neighbor 10.5.80.3 15503088 encapsulation mpls no-split-horizon <- PE4
neighbor 10.5.80.6 14406088 encapsulation mpls no-split-horizon
neighbor 10.5.80.14 14414088 encapsulation mpls no-split-horizon
neighbor 10.5.80.1 15501088 encapsulation mpls no-split-horizon
neighbor 10.5.80.26 15588026 encapsulation mpls no-split-horizon
neighbor 10.5.80.3 15503088 encapsulation mpls no-split-horizon <- PE4
neighbor 10.5.0.126 15188126 encapsulation mpls
neighbor 10.5.200.28 13528088 encapsulation mpls <- PE5
neighbor 10.5.50.89 12588089 encapsulation mpls <- PE6
neighbor 10.5.110.88 14588088 encapsulation mpls <- PE1
neighbor 10.5.140.88 16588088 encapsulation mpls <- PE2
neighbor 10.5.0.89 11589088 encapsulation mpls
neighbor 10.5.170.88 17588088 encapsulation mpls
neighbor 10.5.0.88 15188088 encapsulation mpls <- PE7
How should I do?
Thank you very much.
07-01-2015 11:02 PM
Now, I have a solution is change to configure on ASR9k instead.
Thank you very much.
07-03-2015 03:28 PM
What is the solution on ASR9k?
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: