CE to PE OSPF

[maher]

Hi there,

Normally, at PE, the route of particular VRF is shown as a BGP.I would like to know, it is a normal when there is an OSPF route like below example:

PE#sh ip route vrf vrf1

Routing Table: vrf1

Gateway of last resort is not set

192.168.1.0/32 is subnetted, 1 subnets

O 192.168.1.1 [110/11] via 200.0.0.106, 00:05:15, FastEthernet1/0

192.168.2.0/32 is subnetted, 1 subnets

B 192.168.2.1 [200/11] via 200.0.0.10, 03:42:13

200.0.0.0/30 is subnetted, 2 subnets

B 200.0.0.112 [200/0] via 200.0.0.10, 05:48:31

C 200.0.0.104 is directly connected, FastEthernet1/0

Thanks in advance.

maher

[romccallum]

It is absolutely fine. All that has been done here is that the peering between CE and PE is done using OSPF. Perfectly normal and perfectly acceptable.

[maher]

Thanks for the info.Just curious about OSPF leak into global routing table..just to make sure, whether a correct configuration.

thanks again.

maher