Cisco 9006

[Giuseppe Tomasicchio]

hi, I can't understand if a CISCO 9006 device supports the multilink function on PPP customers, it is used for bonding with 2 or more circuits. with CISCO ASR 1002 it succeeds

[balaji.bandi]

here is some config tips from ASR 9006 documentation :

https://www.cisco.com/c/en/us/td/docs/routers/asr9000/software/asr9k_r4-3/interfaces/configuration/guide/hc43xasr9kbook/hc43ppp.html

[Giuseppe Tomasicchio]

Below is the configuration of the client's interface in bonding (this client has 3 vdsl affixed), the only command we are going to configure is the

Pppoe enables the Multilink group
***********************************************
on the customer side we have this configuration instead
the pppoe-client dial-pool-number 1 command under the Ethernet interface

[Giuseppe Tomasicchio]

hello the device where the application will go the multilink on more ppp client is a cisco asr 9600.
Below is the configuration of the client's interface in bonding (this client has 3 vdsl affixed), the only command we are going to configure is the

Pppoe enables the Multilink group
client side we have this under the ethernet interface this configuration command
pppoe-client dial-pool-number 1
Is it feasible or are there any firmware / IOS limitations?
Thank you