01-05-2012 12:28 PM
Hi,
I need some help to make the configuration below.
We have a point to point metroethernet line from our telecom between our two different locations. Behind the ME swithes of teelcom there is a 6513 switch in one side and a 3845 router at the other side. There is a SPA VPN module on 6513 and we are encrypting the traffic.
We need to pass L2 traffic (tagged) on this line. I want to use the same VLAN at the both side. Is it possible? How can I make the configuration?Any help will be highly appreciated.
Thanks
Sent from Cisco Technical Support iPhone App
Solved! Go to Solution.
01-11-2012 12:17 AM
EoMPLS is an option but requires your ISP to run MPLS and configure the L2VPN for you.
Another option would be L2TPv3, which is a L2 tunnel on an IP network; basically same idea of EoMPLS without the need of MPLS.
Check some guide on that:
http://en.wikipedia.org/wiki/L2TPv3
http://www.cisco.com/en/US/docs/ios/12_3t/12_3t2/feature/guide/gtl2tpv3.html
regards,
Riccardo
01-06-2012 02:08 AM
Hi, EoMPLS does transperent traffic flow over it. Thus this solution works for your case.
Regards, Balaji
Sent from Cisco Technical Support iPhone App
01-11-2012 12:17 AM
EoMPLS is an option but requires your ISP to run MPLS and configure the L2VPN for you.
Another option would be L2TPv3, which is a L2 tunnel on an IP network; basically same idea of EoMPLS without the need of MPLS.
Check some guide on that:
http://en.wikipedia.org/wiki/L2TPv3
http://www.cisco.com/en/US/docs/ios/12_3t/12_3t2/feature/guide/gtl2tpv3.html
regards,
Riccardo
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide