MPLS Configuration

[Ali Bahnam]

Dears,

I have a client with HQ and nine branches, I already connected these branches with HQ by site to site VPN where the platforms are on HQ is Router 2951  branches routers are 2911. 

Now our client asked us to configure MPLS between these branches and HQ so kindly can any one help me to configure the MPLS because I didn't configure it before??

Thanks for your help,

Regards...      

[shivjain]

hi

Please check the below link which can help you to configure the MPLS

http://fengnet.com/book/cddv/ch04lev1sec4.html

regards

Shivlu Jain         

[Ali Bahnam]

Thanks for your response,

I checked the link it is very useful but I have a question:-

on my existing devices the router 2951 and routers 2911 will be the PE routers by another word the routers facing the internet that configured with NAT and VPN will be the PE ?? because after these routers is the ISP.

Regards,

[shivjain]

Hi

The PE could serve VPN customers also or internet customers also thru internet vrf. If you would like to provideinternet thru vrf in that case you could opt the route leaking or simply take the traffic out from vrf and send it to internet.

regards

Shivlu Jain

http://www.mplsvpn.info