I am importing 3 RTs on PE router into a customer VRF. However, now customer has an extranet site from where I need to import few specific prefixes.
I am using the below configuration do let me know if that's fine.
ip vrf TEST
rd 1:11
import map TEST22
route-target export 1:11
route-target export 1:12
route-target import 1:11
route-target import 1:12
route-target import 1:15
show route-map TEST22
route-map TEST22, permit, sequence 10
Match clauses:
ip address prefix-lists: TEST
extcommunity (extcommunity-list filter): TEST
Set clauses:
Policy routing matches: 0 packets, 0 bytes
show ip prefix-list TEST
ip prefix-list TEST: 1 entries
seq 5 permit 10.94.22.154/32
show ip extcommunity-list TEST
Standard extended community-list TEST
10 permit RT:1:20
My Question is do I need to add a Permit any any statement at the route-map TEST22 while calling this as an import map ? & What will happen if I don't ?
Regards
