02-12-2007 04:31 AM
Is it possible to configure TE on a Port-Channel ?
I don't see the command mpls traffic-eng tunnels
CSCO-CORE-SPO(config-subif)#mpls ?
accounting Enable MPLS accounting on this interface
bgp MPLS BGP
ip Configure dynamic MPLS forwarding for IP
l2transport Layer 2 packet over MPLS config commands
label Label properties
ldp Configure Label Distribution Protocol (LDP) parameters
mtu Set MPLS Maximum Transmission Unit
netflow Configure Egress Netflow Accounting
CSCO-CORE-SPO(config-subif)#mpls tr
CSCO-CORE-SPO(config-subif)#mpls
02-14-2007 09:22 PM
Hi,
what software do you use ?
Rgds
Andreas
02-15-2007 03:37 AM
s72033-advipservicesk9_wan-mz.122-33.SRA2.bin
02-15-2007 06:14 AM
Try:
interface GigabitEthernet1/2
channel-group 1 mode active
!
interface GigabitEthernet1/3
channel-group 1 mode active
!
interface Port-channel 1
switch-port
switch-port access vlan 1507
switch-port mode access
!
interface vlan 1507
mpls traffic-eng tunnels
mpls traffic-eng backup-path Tunnel1
mpls ip
Rgds
Andreas
02-15-2007 07:42 AM
Hi Andreas, the port-channel must be L3 in my topology.
Cisco told me doesn't support yet link bundling in MPLS TE (http://www.ietf.org/rfc/rfc4201.txt).
02-15-2007 08:09 AM
if you can't change to that config, use 12.2.18.sxf 5 or wait until it is supported in SR.
Rgds
Andreas
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide