cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
454
Views
0
Helpful
4
Replies

why con't setup tunnel between PEs?

Tom Yan
Level 1
Level 1

hi,i have a problem about multicast for mpls vpn.

ce1-Pe1-P-Pe2-Ce2.

at the core use ssm .but i don't know how to config P.the configuration of Pe:

ip multicast-routing

ip vrf a

rd 100:1

route-target both 100:1

mdt default 232.0.0.1

ip multicast-routing vrf a

ip pim ssm default

the configuration of P:

ip pim ssm default.

but display of the PE:

sho ip pim vrf a nei

only have the interface connect with CE .

why don't setup PEs ?

4 Replies 4

Tom Yan
Level 1
Level 1

i want to know how to config the P.thans !

P-config:

ip multicast-routing

ip pim ssm default

Interface config:

ip pim sparse-mode (on all relevant P and PE interface)

You might also need to enable 'address-family ipv4 mdt' on P/PE, dependent of HW/SW

A verification: show ip pim neigh on PE should show P-router as neigbour

i try to it.it maybe unused.thanks a lot!

thank you very much!i have make it well.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: