Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hi Everyone, I had deployed two ASA5520 as active/standby HA mode. The standby firewall sometimes lost connected from the Monitor server.At that moment, I can't access it via icmp and asdm. But it can be reachable again a few minutes later. ...
Hi guys , I encounter one problem that if 7937 can auto dial one number at one time point . My customer want to the phone can auto dial meetme number at 8:00AM everyday. Thank you for your reply !
Hi everyone, I have read one document called ' implement be6k '. it say only one provisioning application is must be installed. So I don't know if the be6k can run without install provisioning application. Thanks a lot !
hi guys, I have encounter one problem about C4507R. when 4507's cpu is high ,the hsrp cutover. then customer complain the internet is disconect. So I want to config copp on 4507. but I don't know how to do it. Because it is one production network. Wh...
HI everyone, I have encountered one question :ip phone can't fallback to SRST when phone lost connect to CCM before fallback to SRST.I want to know whether SRST FEATURE not support this environment. Thanks a lot !
Hi Muhammad, I just wonder if you have fixed out this issue? I encountered one issue similar with yours. I would like to change the timeout value of transfer to operator. But I don't know how to do it. Thanks in advance!
