- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-15-2023 01:16 PM
I have a Windows 10 VM on VMware that I want to configure for 802.1x. Since the Nexus 1000v is end of life does cisco have another switch I can use to configure my virtual machine for do1x?
Solved! Go to Solution.
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-16-2023 07:54 AM
I believe you need to check two guides on this case.
The configuration of do1x on the Nexus
The configuration of the ISE, considering Virtual machine
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-15-2023 04:38 PM
Hi
It seems there is not replacement for that one. Does you VM run in bridge mode or NAT mode?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-15-2023 09:01 PM
My VM runs in bridge mode in esxi 7
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-16-2023 03:58 AM
You can do the dot1x on the physical switch.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-16-2023 07:47 AM
I tried to configure dot1x on Nexus 9k. The Nexus is not able to communicate with the VM. I am able to use port security on the VM but it's not able to see the dot1x protocols. Do you have direction on how to configure the VM to work on a physical switch?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-16-2023 07:54 AM
I believe you need to check two guides on this case.
The configuration of do1x on the Nexus
The configuration of the ISE, considering Virtual machine
