05-10-2010 03:07 AM - edited 03-10-2019 05:07 PM
Hi,
I am trying to configure the ACS with AD in the identity store but am running into the following issue.
I enter the AD Domain Name and username and password and hit the 'Test Connection' button and receive a DNS error stating that it 'Cannot resolve network address'.
I have logged into the CLI and test to the domain name from there and it works fine.
I am stumped any assistance would be grateful.
Thanks.
Solved! Go to Solution.
05-11-2010 03:17 PM
Hi Andrew,
In the Active Directory configuration, make sure you have entered the full domain name. Along with this login to the ACS through SSH and make sure that the timezone and the time on the ACS and the AD is the same and make sure the ntp server is configured on the ACS CLI.
Here are the steps to do so:
Step 1: Set the time on the ACS corresponding to AD. Type the command "clock {set} [month day hh:min:ss yyyy"
Step 2: Configure the timezone. Type the command in the configuration mode 'clock timezone (timezone).
Step 3: Configure the ntp server. Type "ntp server (ipaddress/hostname).
Regards,
Kush
05-12-2010 02:52 AM
you need to enter FQDN like cisco.com and you would be good to go.
Regds,
JK
Do rate helpful posts-
05-11-2010 03:17 PM
Hi Andrew,
In the Active Directory configuration, make sure you have entered the full domain name. Along with this login to the ACS through SSH and make sure that the timezone and the time on the ACS and the AD is the same and make sure the ntp server is configured on the ACS CLI.
Here are the steps to do so:
Step 1: Set the time on the ACS corresponding to AD. Type the command "clock {set} [month day hh:min:ss yyyy"
Step 2: Configure the timezone. Type the command in the configuration mode 'clock timezone (timezone).
Step 3: Configure the ntp server. Type "ntp server (ipaddress/hostname).
Regards,
Kush
05-12-2010 02:52 AM
you need to enter FQDN like cisco.com and you would be good to go.
Regds,
JK
Do rate helpful posts-
05-12-2010 03:02 AM
Thanks guys.
All working now.
08-10-2011 08:49 PM
Can you please specify exactly what chnages you made to get it working ?
I have similar issue on ACS 5.2 but everything in config looks ok including NTP/timezone and FQDN for the domain name.
However I need to know specifically what changes you made and where so I can compare ?
many thanks,
G
10-02-2012 09:58 PM
Hi andrew,
Can share exactly what changes have you done. I hav ethe same issue with my setup.
Thnks
mbox23ron
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide