Network Access Control

We recently upgraded our VMware infrastructure to vSphere 5.5, and then we noticed that ACS 5.5 is not supported on VMware 5.5.  Does anyone know if there is a plan to support the new version of vmware? Thanks in AdvanceChris Priester

Dear Support Team.we have setup in which wireless controllers are deployed in Foreign & Anchor Scenario. (Guest WLC or Anchor is deployed in DMZ) , Controllers are running 7.3 and CWA config is done as per standard TAC documents.When WLC redirects th...

I have started working with an ASA5512-X with AVC and Web Essentials enabled. Now i would like to integrate this module with our default way of working for network management. Normally we use ACS with Tacacs for network management. Is it possible to ...

Hi,I have a pair of SNS 3514's running ACS 5.4.  They were purchased with a single power supply, and I have since added a second power supply to each one.  I'm looking for a way to confirm that the appliance recognizes  both power supplies and will u...

On my Guest SSID, I have a custom CWA page. It works for everyone except for one Android device.I see the device meet the criteria to hit a certain authorization profile, one that I know has a CWA action of hitting my custom page. This is the same ru...

l have a 3A red led in diagnostic card in a NAC 3350.i can´t find information about troubleshooting.Operational function is not affected. but a red led never is a good signal.I want find how to diagnose if problem is DIMM or slot. how may i do it?in ...

Dear,When trying to authenticate a wifi user against AD we get the following message :Authentication failed : 22056 Subject not found in the applicable identity store(s). AD is reachable, it is the correct domain and the user can be found in the grou...

Hello!I have a simple question:Cisco have route map for integrating Cisco Anyconnect and NAC agent?Because we are have some difficulties with install both clients on PC users.Thanks.

Hello All,I'm using cisco asa 5512-x asdmasa version 9.1(2)asdm version 7.2(1)I configured my ldap server and tested it, connection is ok.but I'm not sure how to configure my ipsec remote vpn, to authenticate users who belong to active directory "VPN...

hi i have ASA5505 i want to get the Authentication from Raduis Server using NPS on windows Server 2012 i test the Raduis Server over "Kerio Control VMware Virtual Appliance" its work Perfect for testing my Setting on Raduis  but with the ASA5505 i ge...

Hi All, I want to monitor  Radius services of ACS 5.4,  In case of failure any radius service on ACS.ACS should send alert to Syslogs  or email notificationIs there any way to monitor Radius services ? Anyone have any idea how to monitor. Regards.

I am working on setting up a new ACS 5.5. server and we are trying to move to having Active Directory be our authentication/Identity portion of our device management. I have noticed that the only choice under the "Access Policies/Access Services/Defa...