Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I recently migrated users from an 8.6 to 11.5 cluster and, between fixing all of the table errors caused by db changes between versions, we ended up with 45,000 subscribed services for 8,000 endpoints. Exporting and re-importing was going to be a nig...
Hi all,Home services in Australia are migrating over to SIP and mine has just been changed over. As a UC engineer I've got an old 7945 handset that I'd like to deploy, but have little experience getting them working with anything other than CUCM. Doe...
I have a strange issue with caller ID on Jabber 4 Windows. I have a SIP trunk to an ITSP where called and calling numbers are 9 digits long e.g. E.164 without the country code. I use calling party transformation patterns to turn the caller ID into +E...
Hi All,I'm trying to configure ISE so that a local site administrator can only edit devices and users in his location, and only view reports/authentications for users at that location. I've tried setting the data access permissions to only view his l...
Hi,My CUPS server is complaining that the CM publisher's NTP isn't working. The publisher is a CUCM-BE and a show ip preferences shows that NTP is blocked by the firewall. It's synced fine to our internal NTP servers but won't let anything else sync ...
DialPlan.xml is also required. This is for a 10 digit closed Australian dial-plan and can probably be tidied up but it works<DIALTEMPLATE> <TEMPLATE MATCH="12...." TIMEOUT="0"/> <TEMPLATE MATCH="13...." TIMEOUT="0"/> <TEMPLATE MATCH="1300...
Thanks Nuno, I got it working. I knew that it was possible and was hoping that another UC engineer had been through the pain since most forums have people who don't have a good foundation of SIP. I'd not seen the 78xx supporting it, but it's too ...
Got it registered finally using 8.5.4 firmware. TFTP server is my NAS on my home LAN, and I set option 66/150 on my DHCP pool on my router. Sanitised config is below.<device> <fullConfig>true</fullConfig> <deviceProtocol>SIP</deviceProtocol> ...
I've just loaded 9-4-2-1SR3-1 and although it's resolving the SRV record of the ITSP, my packet capture shows no traffic after that point. It's not even trying to register. Forums have said this is a known problem with some older firmwares, so I'll t...
Thanks Sreekanth,
Between this video and the Cisco Live Berlin presentation I now have a good handle on normalisation. I'm stuck converting a SIP-profile from CUBE to Lua (the CUBE is managed by a network team who don't know voice).
The profile;
voic...
