Network Access Control

I think I understood the customer concern. This is quoted from Microsofthttp://support.microsoft.com/kb/321051"The Lightweight Directory Access Protocol (LDAP) is used to read from and write to Active Directory. By default, LDAP traffic is transmitte...

Hi All,I am running ACS4.2 and want to configure a group for access to only specific devices.I have setup a group in AD and matched this to a group in ACS. Under Network configuration, I've added the device I want the users to access.In group setting...

I am trying to build a distributed deployment with the following personas:2 policy admin nodes2 monitoring nodes4 policy service nodesThis was a project that was partially implemented but never in production. It was in a distributed deployment, but h...

Folks,i am using the guest portal on ISE and WLC and i saw that all papers and guides are requesting that you need to use the Authentication (Web Policy) under Layer 3 security WLAN but for me just using the Passtrough option works fine, when i use t...

We are currently using Cisco ACS 5.3 integrated with Active Directory for authentication to our Cisco devices. We are looking to move to smart card logins and trying to find out if this is possible to authenticate to the console/ssh on the router/swi...

All,Can I just check my thinking?In the old ACS 4 world you could use HCAP to offload posture checking to Microsoft NAP as in:http://www.cisco.com/en/US/solutions/collateral/ns340/ns394/ns171/ns466/ns812/guide_c07-491729.htmlI don't see anything for ...

Hello,    I´ve a Alctel IP-Phone authenticated via 802.1. A PC ist connected at the Phone using MAB. When the PC will be disconnected the session remains for ever. The session can be cleared with the inactivity timer. The PROBLEM is....when the PC is...

I have configured new NTP servers on our primary ISE node (admin and monitor persona). I have saved the config. Ideally the primary admin/monitor node should now sync new ntp servers to secondary admin/monitor persona node as well as to other PSNs. B...

Hello, I have performed the following configuration on one of my switch to test periodically the availability of ISE servers : radius server ISE-1 address ipv4 1.2.3.4 auth-port 1645 acct-port 1646 key 0 toto123automate-tester username radius-test id...

Hello!We are implementing BYOD concept with ISE (1.1.4) and WLC 5508 (7.4.100).On WLC there is SSID(WLAN) with MAC filtering without L2 security. For authentication user is redirected to the ISE Guest Portal. Credentials are created at the ISE sponso...

Hello all,not long time ago, i lost all data in the HOME pannel, all sub windows says: no data avalable no nothingthe only number i have there is the number of endpointsAnd now, in the live authentication, i dont any results, no pass, failed etc... r...

G'day All, Is anyone aware if it is possible for ISE to push a URL redirection to user devices once they have passed the posture assessment? I am deploying a wireless BYOD ise deployment with AD auth and posture assessment, and we are hoping to find ...

Hello.I have the problem. I added to ISE the device 3750X. As snmp password I use qwerty12, password for the radius password qwerty12.On the device, the following configuration file:aaa server radius dynamic-author client 192.168.100.21 server-key qw...