Network Access Control

Hello,I'm am looking for a OID to poll the status of dot1x configured ports, when the port has been disabled due to a DOT1X-5-FAIL I would like to see this when polling the switch. So far I'm not able to I have used the MIB's below, but I can't finds...

hellois it possible to use wildcards in Compund Conditions in ACS 5.2? i've been suing the following to try and match a username that contains @*.*:This would hopefully match a username like j.blogs@somewhere.com but doesn't work as expected - am i d...

I'm installing ACS4.2 in our lab domain and want to leverage the corporate domain for authentication.  The one way trust is in place, but there is a facet that I'm not clear on in regards to the installation requirement.I'd like to install ACS on a l...

Accessing the access point via telnet radius authentication works with no problems.  When I access via secure http I can authenticate, but I get level 1 or read access only.  Can someone assist.  Below is the config for the device.  no service padser...

On the CLI, we have ACS showing:clock timezone Etc/GMT-6!ntp server 10.10.10.1A show clock shows the correct local time.  When in the GUI of ACS the clock reads Tue Aug 30, 2011  21:13:58 GMT+06:00  Our NTP server is showing the correct local time al...

Can anyone help?  This prevents the PC from passing posture assement and places it in a "temporary role".  I know how to disable the scan, but we would like it to work correctly.Same results on several PCs, Windows Xp SP2 or SP3, Windows 7 (32 or 64-...

I want to configure IEEE 802.1x port-based authentication on cisco switches, preferable 2960 series. Which models support this feature?. I have try with some older switches but it doesn't works properly on everyone. I have upgraded them whitout bette...

Hello! Our company has installed ACS Version: 5.1.0.44.6 Internal Build ID: B.2347 with patches: 5-1-0-44-5, 5-1-0-44-6. The security policy of our company includes a password change every 3 months. Our programmers had written a script that allows us...

I know that ACS 5.2 does not support maximum number of simultaneous sessions as of yet.  Is there a way to tell if I am exceeding the maximum user sessions?  I have about 50 clients authenticating to ACS 5.2 currently without problems, but also have ...

HelloI have a question about ACS RADIUS authentication with Alteon 3408 L4 Switch.I configured a ACS 4.2.1(build 15 patch 4) software for windows on Windows Server 2008 Server STD.TACACS authentication with CISCO product was successfully passed.but R...