Network Access Control

Hello all,I have some problems with the dynamic users. I want to move them to another group and do some changes on userid, but I also want that they are replicated then. The first is no issue, the second is, since they stay flagged as "dynamic users"...

I want to setup a couple of users in TACACS using ACS 5.1 to only be able to login to the ASDM and monitor the device.The documentation is a bit confusing from the ASA ASDM as it says:1.TACACS+ users—Authorization is requested with the "service=shell...

Hi, with IOS router and switch I'm able to authorize the user to jump automatically to the correct privilege level in login phase, as configured in authorization privilege field in ACS. With PIX/ASA the jump does not run: why ?thank you in advanceRS

i have configured the network device group and assigned some dummy entries of acs servers have been added. now what i exactly want is, i want to remove the unnecessary entries in NDG ans also which are added in "Not assigned group". because i am addi...

I am trying to get a WLC4404-100 to use a ACS Express 5.0 for authentication to the WLC for administration. I have the device in the ACs but it does not authenticate any users. If i switch to RADIUS on the WLC with Local as secondary in the priorit...

Hi,My ACS is integrated with AD(member of domain server) and ASA(8.2) is authenticating domain users via ACS successfully (by test aaa command) but my SSL vpn users are not able to authenticate with AD however ssl vpn user can authenticate with ACS u...

I'm new to IOS but I'm taking ICND 1 and ICND 2 to catch up. I've gone as far as configuring a 3560 switch from "scratch" in a test environment, and am in part one of ICND 2.Setting this switch up for HTTP administration, I've been prompted repeatedl...

Hi all,        I have Cisco ACS3.2 (windows) and had pix 6.3(4) and access vpn users were authenticating from ACS with radius protocol.I upgraded pix ios to 7.2(2), now access vpn users can authenticate till group and cannot authenticate user credent...

AllCurrently running 4 ACS 5.1 servers to load balance our 802.1x requests, but am getting an error message which is a bit unhelpful in terms of details.The error message is11051 RADIUS packet contains invalid state attributeand only seems to occur o...

Can someone give me some pointers on how to configure Cisco ACS to accept the enable password from a router using Radius rather than using the local enable password. Do I have to use the Radius attributes to achieve this? The AAA radius configuration...

Hello Dears,I m facing problem when i try to install the ACS 5.1 on VMware, It give me error COULD NOT FIND KERNEL IMAGE :LINUX when i try to boot from DVD ,it is a  Evaluation version download from Cisco.com Thanks

Hi,I ve got my clients authenticated through ACS and created two different command sets ,tested as well.Kindly advice how to backup Acs data as we are using two ciscoTACACS servers1113 one would work as fail over .