Network Access Control

hellowe are using ACS4.2 to authenticate network admins to access switches and routers. ACS is integrated with Windows Active Directory.so we map AD groups to ACS groups and we specify access restriction in ACS groups.now we want to use this ACS to a...

Dear allI have a switch and I need to do a supplicant auhentication.I tried the same NEAT config. which is in the document but in the ACS I got a failed attempts and the reason is EAP type not configured.Switchs 3560ACS 4.1(1) Build 23 Patch 5Any hel...

hi! how do i do a graceful shutdown for my ACS and NAC svr?thx

Hi,I have enabled the Dot1x Authentication on a Switch Port in a Cisco 4500 Switch running Cisco IOS Release 12.2(50)SG6.bin.I have configured the Dot1x Configuration.When i give show authentication sessions in fa 6/38 i get the output but without th...

Hi,we have two different Version of ACS Appliance v3.3 and v4.0.Now when i connect in v3.3 to a Switch then i been not in the enable modus and with v4.0 i been in the enable modus. I look the User setting the Group settings and all the other settings...

If you wanted to stand up a ACS solution in your environment, which is the better choice at this time? Is 4.2 going to be around, or is it going away for 5.x in the near future?

Hello everyone,We had a scare yesterday.  We had a wireless outage yesterday and we came to find out that it was because the CSauth service was not running on both our ACS's.  New user's or user's trying to re-autenticate were unable to.  We have 2 A...

We have a fairly static environment and I was thinking about configuring MAC authentication on the ports of my access switches - any drawbacks or reasons not to?

Hi All, any one  has done the implementation of command authorization with ACS.I want to create a command set in which user can only run show command which i specified and some command in configuration mode like assigning vlans to switch ports.I have...

Hi, I have following issue. I am using an  OpenLDAP server to authenticate IPSec VPN Client users. It works to authentivate against an OpenLdap server.  But my problem is, that I want to have two different Group Policies depending on the LDAP group u...

Has anyone found a good way to migrate users/groups from ACS on Unix(2.3.6) to ACS on Windows (3.3)?