Network Access Control

Hello,I'm working with a Catalyst 5509. We can log into the router module, but not the switch module. When logging into the 5509 switch, the system prompts for enable password. After the password is entered - the session stops. There is no response f...

We are upgrading to ACS 4.2 that will be used to authenticate wireless users. It seems that if I limit simultaneous connections (for wireless users) to 1, then disconnect from wireless it takes around 3 minutes for ACS to release that connection so I...

I re-installed the ACS Remote AGent (4.2) on a host where it was previously working. All permissions are still intact and the service has been reset to use the correct account. There is not CSWInagent log file but I do see this in the CSAgent log:ACS...

We have two Cisco ACS 1113 4.2 "Solution Engines" running Windows. They are in test. Is this the most current software base for the 1113? My memory is telling me there was a Linux-based version in the works. Is that true? Is that available?

Hi,We have a ACS 4.2 on MS Win 2003 configured to get accounts from external database via Generic LDAP. It is a Novell EDirectory of last version. It works well we can authenticate users, but we have problems with group mapping. When we try to do thi...

I've searched through the forums a bit and there were several conversations that similar to what I was doing but I could not find any that were exact. Here is my scenario:One ASA5520 as the Remote Access VPN head unit (IPSEC).One Cisco ACS Server for...

We have an internal subnet (Secured Server LAN) that requires network authorization. This subnet contains a separate AD forest with the servers as members of the domain. The Windows XP clients that access these resources are also members of the secur...

Hello, I have a flashing red light on my ACS. I have searched on Cisco.com to see what this meant and how I can fix it. I am aware that it is a critical error on the system health for my ACS. But what exactly does that mean? How can I figure out what...

i have cisco ACS solution engine 1113 , when i power up the appliance , it gives me the following output:ThinkVantage Secure Data Disposal Utility 3.Date and time of execution ... 03/21/08 07:21:48Command executed ............. A:\SCRUB\SCRUB3.EXE /d...

We currently have SE 1112 and are using two (one primary, one backup). I recently upgraded my primary from 3.3.3.11 to 4.1.1.23 and had some issues after the upgrade. After some time, the ACS would stop responding via the GUI or just be extremely slo...

Which has a higher priority, group or user settings?If a user is a member of a group with only level 1 access, but an ACS admin sets their user account to have level 15 access, which would be applied?We are delegating ACS user creation to a different...