Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Our tacacs sits on the other side of a pix firewall. As a result we are causing alot of xlate transactions on the pix as we enter commands on our devices. What are the suggested timeout values?Our conn count is max 2700timeout xlate 3:00:00 (default)...
In order to remove a module I am not using in a 6509. i attempted to run this command from global config mode. I think i might need to log into the IDSM-2 CLI ?For Cisco IOS software: hw-module module module_number shutdown
Got a question in regards to ethereal capturing a source and destination set of ip addresses that do not include the ip of the device that I capture on. Is this due to promiscuous mode?Say the capture nic card is 10.0.0.1 I am getting in some of the ...
I have 11mb of free space in flash and want to perform software distribution with a 7mb ios. I get :Warning - SWIM1049: The selected image requires Flash to be erased during image upgradeI know I can blow away the .bin file and then submit the job an...
I have a 6509 (distribution, running 12.2(17d)SXB5) and a 6506 (core, running 12.2(17d)SXB1) device that both show Giant counts incrementing. Wanted to know what is an acceptable percentage of Giant packets, and any tips for determining the cause (ca...
the command does not go in, comes back with unknown command and with the '^' pointer. I was attempting to run this in global config mode, not enable. Perhaps that was the issue?
