Network Access Control

Hi,Basically the problem is that I am working with old routers, checked already on feature navigator an the following commands are not supported on the router to communicate to a TACACS server that resides on a vrf:-----------------------------------...

I am looking for a similar configuration for my Cisco PIX & ASA to configure with Cisco ACS, with the below said commands I could able track what command a user has entered on the switches/router. Any help is highly appreciated for me to configure in...

Hi all! I'm having problem with configuration AAA authorization. I'm not authenticate from outside, output message "user none". But inside I can authenticate normally. Following configuration not working: aaa new-modelaaa authentication login default...

HiIs it true? TACACS+ will not work with 802.1x port authentication because EAP is not supported in TACACS+, Where to find the documents about Tacacs+ doesn't support EAP?Regards, Thanks.

Hi folks,I regularly get these messages from my ACS box, which is (among other things) supporting 802.1x / PEAP authentication for my wireless users.Note that the misspelling of "authentication" is intentional - e.g. the typo is in the syslog coming ...

We are in the process of setting up AAA Accounting to a Radius server from our switches,wireless controller and VPN. We are trying to figure out what the logic, or interval is that the devices send 'Interim Updates' to the ACS. Right now the interval...

hello,Could anyone give me some hints on how to configure accounting, for ssh/telnet access on a router, that integrate the following infos :start and stope times, duration of the session, packet and byte counts.Thank you.regards

Hi,I've configured two ACS servers with replication but i noticed that when the replication takes place it overwrites the AAA servers table configured in the network configuration of the secondary server and that makes the next replication to fail be...

Wired users.When PC boots up and tries to perform "computer authentication" with ACS and then Win2003 AD, I get the following error:"External DB user invalid or bad password"Thanks

I had deployed a L3 Virtual Gateway mode for NAC appliance. There is ACS for authentication. How can I add ACS to "Auth Servers". CAM settings do not need mapping rules. Every user just anthenticate oneself's account, then CAM can pass these info to ...

Can one ACS server authenticate users against two different AD domains? The server is a member server of one domain. We are not able to enumerate the groups from the second domain. There is a two way trust between the domains.

Problem cannot console into the ACS 1112 but need to get the ip address off it.Anyone know how to break out of the Cisco Lock Screen when booting with a video attached?

I upgraded two ACS SE to version 4.1.1.23.5 to solve this problem TACACS+ Command Accounting does not work.they were working ok, but the replication between them started to fail. these are the messages that i receiveACS Primary: ACS 'backup' has deni...