Network Access Control

General question around authentication servers supported with VPN 3000 family. Is it always assumed that the authentication server resides on the private LAN side of VPN? For example, if I have a multi-site setup where the Authentication server is re...

Can someone help me with the command syntax to configure a Cisco VG200 for TACACS+? Specifically, how do I enter the tacas+ server and key. Thanks.

Hi there,can anybody tell me how to set up aaa check of ISDN caller ID under Cisco ACS 3.0 on a per user basis for incoming calls ? I already have set-up aaa for DDR (RADIUS), i need this as an alternative to callback .My first idea was to use CISCO...

Hi,I didn't understand what's DSM module for ACS 2.3 Unix,what's the function of this module?Thanks, Giovanni

Hi AllI need to roll out a RAS solution but there are some issues that I am unsure off. Firstly, I have purchased a Cisco Secure acs 3.0 which has been installed on an NT server, how reliable is the tacacs+ service, I am taking username and passwords...

Hi,I'm using cisco vpn client 3.5 for my mobile users to connect to the network through the Pix 515 firewall. The users are getting authenticated using a Win 2000 server over RADIUS using "aaa-server" command This command allows me to mention only ...

Consider an operational ACS V2.6 on NT . We want to migrate to W2000 and for this we receive a brandnew W2000 Server on which we will install ACS V3.0Can we backup the configuration & DB from V2.6 and restore it on V3.0 ?Or can we use DB replication ...

i have a PIX 515 (6.1(2)) that accepts VPN connections. i'm currently using an internal RADIUS server (NT4.0 IAS) for authentication, and that works very well. however, i need to be able to authenticate to 2 different RADIUS servers (in 2 different...

I'm using ACS 3.0 with a 3640 NAS with analog modems and channelized serial interface. I'm configuring authorization to ppp dialup users to specify which resources they can see and which others they cannot see. Is it possible to perform this kind of ...

What is the stable version of ACS ? Is it version 3.0 or 3.1 ?

I have upgraded my VPN3015 to v 3.6.1 and since have been getting quite a few of these errros every day. I have searched but cannot find any reference to this error. Can anyone tell me what my concentrator is tring to tell me? I am not getting any co...

We are looking at migrating from Shiva SAM 5.0 to ACS 3.1 - I am looking to find users who may have done the same thing. Does anybody know of any additional information resources to help with the migration?Any information about your experiences woul...

I've enabled TACACS+ authentication for telneting into PIX and managing it by entering.aaa -server MYTACACS protocol tacacs+aaa-server MYTACACS (inside) host 10.1.1.1 secretkey timeout 15aaa authentication telnet console MYTACACSaaa authentication e...

I have the following scenario:We have one PIX 515E with latest image and one ACS 3.0.2.We would like to limit which netadmin may use which command on PIX.We have created the user accounts on ACS, and AUTHENTICATION is working fine. Under user Advanc...