Hello, We encounter a problem when the WAN link is cut between the remote site and the Datacenters. However, we have a domain controller server on the remote site which is not taken into account during these cuts. Is it possible to prioritize the cal...
Hello Cisco brains, I recently deployed Cisco ISE (3.1P3) and I'm running into an issue with Anomalous Behavior and Detection. I understand that in order for ISE to trigger an anomaly, it must hit the following:NAS-Port-Type - Determines if the acces...
hello.After installing ISE 3.1, the license was added through Smart License normally, but still the error as shown in the picture is displayed. Having trouble with the license addition process?
Dear @ciscoCommunity @ISE ,Greetings for the day.I have put 4 conditions for posture Firewall, File, USB and anti malware.However when I delete specific file and turn off Firewall of system it does not auto remediate as I have selected option for aut...
Hi,So i integrated my Firepower and ISE. I have a policy that trigger the ISE to quarantine or block the user access to my network. All of that work, but it got me curious. What method does ISE use to quarantine endpoint? Is it dynamic ACL? if it dyn...
HiI have a strange issue and no doubt I'm missing something basic but it has me scratching my head.I've been playing around with Guest portals. I have Guest 1 on Gig1 and Guest 2 on Gig 2. In my authorization profile I supply the portal IP address ...
Is there a way to synchronize ldap user authentication on Meraki MX250 Firewall?
Hi All, I'm trying to configure Wireless 802.1x with PEAP and I understand for ISE to verify the user certificate that it will present, I need to have a Root CA in the list of 'Trusted Certificates' within ISE. I've imported that as follows: That's ...
Hi All,I'm trying to configure cisco 3560 for basic 802.1x with ISE 2.6. I have a single PC attached to gigabitEthernet 0/1 but I dont see any pop up on PC to enter username and password. Not sure dot1x is supported on this switch but all the command...
Hi,I've tried to setup the ISE to authenticate the PC with (802.1x or MAB depend on the PC type)The connection must have IP-phone direct connect to switch port and then connect to the PC.Below is the port configuration. interface FastEthernet0/1descr...
Hi guys, deploying SDWAN/SDA fabric across an enterprise. Mainly hardware refresh to Nexus 9K but in some remote locations there are legacy networks/server farms 'out of scope' that are connecting in on legacy hardware such as a Cisco 2900 router or ...
I am new to this and starting into configuring our ISE servers with policies for allowing endpoints to authenticate using 802.1X. I am taking a phased approach to this so I don't accidently shut down the whole network. After much research, I started ...
Cisco NCS 5501 to log to syslog all successful and failed login attempts to the NCS via any interface? I'd like to get as much verbose information about the login attempts (success and failed) as possible,possible including source ip address, userid ...
Hi everybody. I need help with this particular problem. Although I have seen it raised and solved on this particular forum many times, I struggle to understand the way it is solved since I'm just a user, not very tech-savy when it comes to network co...
Hi Team,I have implemented dot1x with cisco ISE.Below is switch configuration.SW1#sh runBuilding configuration...Current configuration : 6616 bytes!! Last configuration change at 21:06:15 UTC Mon Mar 1 1993!version 15.0no service padservice timestamp...
