https://community.cisco.com/t5/security-knowledge-base/ise-version-upgrade-matrix/ta-p/3653501 I will be upgrading from 2.7 to 3.0.What patches are required from 2.7?The table on the left says the last patch is required,The table on the right says y...
Hi AllI'm having some issues with ISE profiling Cisco IP Phones correctly. I setup an authorization policy to allow any Cisco IP Phone on the network. However the policy is not getting any hits because the IP phones are being detected as Cisco-Devi...
Hi All,We have a requirement to restrict the maximum number of 2 endpoint devices connected per user. Is there anyway we can achieve this in ISE for dot1xBr,Shine
Hi all;In my ISE implementation (ISE 3.2 Patch 6), in the main dashboard, the numbers appeared in the "Total Endpoints" section is different with "Endpoints" section. Should these sections show the same report? If yes, how can I resolve this problem?...
Hey guys I'm having an issue with my ISE licensing that I have not been able to figure out. I had a standalone ISE VM on an air gapped network with a PLR. A couple of months ago, the VM crashed and had to be rebuilt, so it has been on an eval license...
When we backup via WEB, we see the progress stuck at 0%. （1）We've tried to Force Backup Cancellation, but the output is "No stuck backup found. Exiting" ISEA/admin# application configure ise Selection configuration option[1]Reset M&T Session Database...
Hello, We have an licensed ISE 3.3 (not evaluation) with a lot of Essential and some Advantage out of compiance because of the number of licenses consumed versus purchased. ISE is showing 24 days out of compliance... Please can you tell me if there i...
One of our customer sites has guest wireless access through ISE 3.3 with an integrated SMS Gateway, using self-registration portal that is currently working fine. now they come up with a new requirement as mentioned below, Current Working Scenario: G...
Hello All,We have weird experience in using v3.2 patch 4 with Sponsorship guest access, we deployed SSID with guest access need to register and sponsor need to approve. When guest registered using their personal email (ex. guest@yahoo.com) and input ...
ISE 3.3 Patch 2 with NDFC - Internal User gets disabledHello all, we have an issue with an internal user on ISE which always gets disabled after some time. Or rather NDFC can not authenticate with a given user anymore. This user is used by Nexus Dash...
Hello,We had a perfectly functional ISE 2.7 posture deployment, but we had to upgrade to ISE 3.2.We set up another deployment & imported our 2.7 conf into the 3.2. Since then, our computers never go through the full posture process.We're using Anycon...
Hi what is the best way to change ISE network interface. by default, it is using the copper port but we need to use the 10gb SFP port. can we shutdown the eth0 and config the ip on the spf port? or set the sfp port as secondary port the just connect ...
Hi team! We have been struggling with an issue after migrating our ISE deployment from 2.6 to 3.1 last year.We found out that accounts used for Wifi guest solution stop working properly after 21 days of being created using the Sponsor portal. The be...
HI all,I have a cisco switch that no longer gets DACL's from ISE. I've tested radius connectivity and all is fine. When doing a pcap off the PSN i see the name of the DACL called "BLAH" (makes it easy to search for in PCAPS) but i never see the PSN...
hello we are preparing to upgrade an ISE install from 2.7 -- 3.2 please see attached screenshots I ran a precheck and got a platform warning Q has the community got any ideas how to resolve this issue ?
| User | Count |
|---|---|
| 5 | |
| 4 | |
| 3 | |
| 2 | |
| 1 |
