cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
708
Views
0
Helpful
11
Replies

PAN/Mnt/PXGrid and PSN virtual deployment

ibrahimbadr4669
Beginner
Beginner

Dears,

I have two nodes  (PAN/Mnt/PXGrid and PSN ), I have to choose which one will be on appliance 3615 and which one will be on virtual deployment?

1- PSN virtual and PAN/Mnt/PXGrid on the appliance  

2- PSN on appliance and PAN/Mnt/PXGrid virtual 

Thanks and BR;

1 Accepted Solution

Accepted Solutions

hslai
Cisco Employee
Cisco Employee

@ibrahimbadr4669 If your access to both virtual and hardware appliances are the same and the both types have the same performance characteristics, then it does not matter how you assign the personas. You may always swap the personas around later.

View solution in original post

11 Replies 11

balaji.bandi
Hall of Fame
Hall of Fame

i go with the below :

2- PSN on appliance and PAN/Mnt/PXGrid virtual

also make sure you choose right VM compute resources.

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

ibrahimbadr4669
Beginner
Beginner

Thanks alot Balaji for your kind support, is there cisco document discuss this subject

some of the things not documented always it was experience we suggest.

to be honest if you do not do compute properly on Virtual environment ISE struggle lot - compare to appliance which was tuned for ISE to run as expected.

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

ibrahimbadr4669_0-1693462304743.png

 

ibrahimbadr4669
Beginner
Beginner

if we use virtual for PSN, if the it's fail. I Think it's easier to recover it . Is the virtual has performance issue so HW is preferred as PSN do the main function of ISE. Is that Right ?