03-23-2011 12:22 PM - edited 03-10-2019 05:56 PM
I am looking for a sample configuration for doing TACCAS+ on ACS 5.2 with an ASA 8.2.2.
Any help would be appreciated.
Solved! Go to Solution.
03-29-2011 07:05 AM
I think the following should just about do it - However it is MUCH simpler to do this in the GUI
aaa-server TACACS protocol tacacs+
aaa-server TACACS (management) host x.x.x.x key ****
aaa authentication http console TACACS LOCAL
aaa authentication ssh console TACACS LOCAL
aaa authentication serial console TACACS LOCAL
aaa authentication enable console TACACS LOCAL
aaa authentication telnet console TACACS LOCAL
aaa accounting ssh console TACACS
aaa accounting telnet console TACACS
aaa accounting serial console TACACS
aaa accounting enable console TACACS
aaa accounting command TACACS
Remember you need to create the network device in ACS with the same shared key.
Paul
03-29-2011 07:05 AM
I think the following should just about do it - However it is MUCH simpler to do this in the GUI
aaa-server TACACS protocol tacacs+
aaa-server TACACS (management) host x.x.x.x key ****
aaa authentication http console TACACS LOCAL
aaa authentication ssh console TACACS LOCAL
aaa authentication serial console TACACS LOCAL
aaa authentication enable console TACACS LOCAL
aaa authentication telnet console TACACS LOCAL
aaa accounting ssh console TACACS
aaa accounting telnet console TACACS
aaa accounting serial console TACACS
aaa accounting enable console TACACS
aaa accounting command TACACS
Remember you need to create the network device in ACS with the same shared key.
Paul
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide