12-30-2019 01:42 AM
Hi Experts,
Is there any support for Cisco SF500 and Cisco ISE 2.4.
Since I do not see this switch listed in the compatibility matrix here
If it supported, then does it support, redirection, CoA and VLAN change via ISE posture profile.
Any pointer is much appreciated.a
Solved! Go to Solution.
01-05-2020 02:23 AM
I don’t believe it’s up to ISE to list the support of all potential devices. Check the switch’s Admin/User Guide .
If the switch supports RADIUS then you’re half way there. Check if it supports COA (RFC3576). Dynamic VLAN assignment should also be pretty standard.
Even if its RADIUS support does not conform to other Cisco devices, ISE can be configured to support custom attributes and even Custom Device Profiles.
01-06-2020 08:52 AM
@Arne Bier wrote:
I don’t believe it’s up to ISE to list the support of all potential devices. Check the switch’s Admin/User Guide .
If the switch supports RADIUS then you’re half way there. Check if it supports COA (RFC3576). Dynamic VLAN assignment should also be pretty standard.
Even if its RADIUS support does not conform to other Cisco devices, ISE can be configured to support custom attributes and even Custom Device Profiles.
Correct, Please use Does ISE support my Network Device
01-05-2020 02:23 AM
I don’t believe it’s up to ISE to list the support of all potential devices. Check the switch’s Admin/User Guide .
If the switch supports RADIUS then you’re half way there. Check if it supports COA (RFC3576). Dynamic VLAN assignment should also be pretty standard.
Even if its RADIUS support does not conform to other Cisco devices, ISE can be configured to support custom attributes and even Custom Device Profiles.
01-06-2020 08:52 AM
@Arne Bier wrote:
I don’t believe it’s up to ISE to list the support of all potential devices. Check the switch’s Admin/User Guide .
If the switch supports RADIUS then you’re half way there. Check if it supports COA (RFC3576). Dynamic VLAN assignment should also be pretty standard.
Even if its RADIUS support does not conform to other Cisco devices, ISE can be configured to support custom attributes and even Custom Device Profiles.
Correct, Please use Does ISE support my Network Device
01-07-2020 02:34 AM
Yes, understood. Integrating any other switch than the one listed in the matrix would require some more testing efforts from our end.
Just make sure that those NAD support either Radius CoA or SNMP CoA to start with.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide