09-25-2018 11:14 AM
Hi All,
Hope you all are doing good.
Please help me on below requirement.
We are looking for a 802.1x setup for Wired and Wireless in that we want to have 4 vlans, one vlan for wired dot1x and second vlan for wireless dot1x, third and fourth vlan would be Quarantine vlan, one for Wire and another one for Wireless.
Why we need this because our requirement is like that whenever any user connects to our networks irrespective of Wired and wireless we want to put him/her into quarantine vlan first, in quarantine vlan all posture operation should happen, once device become COMPLAINT then it should move into our corporate Wired/Wireless network or if its not COMPLAINT then it should have limited access to our network from where device will get the required things to become complaint.
I know the configuration of ISE but not sure in Switch configuration, So any one help me in complete switch configuration from start.
we have One Core SW(3560) and one Access switch(2960) for testing.
Confused in, on which switch i should create all vlans, will it be on core or access and what ports i should put in what vlan.
I wan't to have DHCP also on my core switch for all vlans.
Request you all to help me on this.
Thanks in advance.
Regards
Sajid
Solved! Go to Solution.
09-26-2018 02:09 PM
09-25-2018 12:06 PM
09-25-2018 08:38 PM
09-25-2018 05:20 PM
Hi
What exact version are you using and what exact model? I'm asking this to give you a config snippet using legacy or IBNS2.0 (if supported).
At high level:
- you create vlans on both core and access switches
- you create your SVI on your core switch
- You can pre-setup all ports to be in quarantine vlan and then you'll change it depending on your posture status.
09-26-2018 01:33 AM
09-26-2018 02:09 PM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide