1346
Views
0
Helpful
1
Replies
VLAN DHCP release on ISE
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-09-2017 01:57 AM
My customer tested VLAN DHCP release function, and found that it becomes an error (ui_vlan_install_error_message) when they waited for approximately 60 seconds without pressing both buttons of "Install" and "Don't Install".
[Q] Can we change this time-out value(60sec)?
Thanks,
Kazuhiro
Labels:
- Labels:
-
Identity Services Engine (ISE)
1 Reply 1
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-13-2017 08:37 AM
Assuming this about NAC agent or AnyConnect ISE posture, then there are some configurable items in an agent profile. For example, below shows the parameters for Posture Agent Profile Settings:
