06-04-2020 10:50 AM
I am having an issue with a management only interface g 0/0 that is part of the Mgmt-vrf, so as a part of troubleshooting, I want to move this connectin to a network interface g 1/0/24. See g 0/0 config below:
Cisco 3650 IOS 16.9.4
!
interface GigabitEthernet0/0
description MGMT --> IO-MGMT-SW5 1/0/21 Conn ID 29.17
vrf forwarding Mgmt-vrf
ip address x.x.x.x x.x.x.x
speed 1000
no negotiation auto
spanning-tree portfast
!
When I apply the config to the g 1/0/24 interface, it takes the commands, but does not display the "VRF forwarding Mgmt-vrf".
!
interface GigabitEthernet1/0/24
description MGMT --> IO-MGMT-SW5 1/0/21 Conn ID 29.17
no switchport
ip address x.x.x.x x.x.x.x
speed 1000
spanning-tree portfast
end
!
Is this because only one interface can be in the Mgmt VRF at one time?
Solved! Go to Solution.
06-04-2020 11:42 AM
are you configuring the same IP address?
You have N number of the interface in same VRF,
you need to follow the order of operation :
default interface GigabitEthernet1/0/24
interface GigabitEthernet1/0/24
vrf forwarding Mgmt-vrf - as soon you issue this command the interface belongs to VRF all the config will be lost.
Then configure IP address
06-04-2020 11:42 AM
are you configuring the same IP address?
You have N number of the interface in same VRF,
you need to follow the order of operation :
default interface GigabitEthernet1/0/24
interface GigabitEthernet1/0/24
vrf forwarding Mgmt-vrf - as soon you issue this command the interface belongs to VRF all the config will be lost.
Then configure IP address
06-05-2020 12:42 PM
Thank you. I was able to test this with a different IP and it appears to be successful
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide