Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, Our team is having an internal discussion regarding the Cable diagnostics test "test cable-diagnostics tdr interface xxx" command and if POE should be turned off when running the test. One group believes that if the end device requires POE, yo...
I currently have (5)3650's stacked together, but need to add more ports. I know we can stack up to (9) switches together, but my network architect is saying that while you can, 5 switches is the sweet spot and he is recommending we start another stac...
I am having an issue with a management only interface g 0/0 that is part of the Mgmt-vrf, so as a part of troubleshooting, I want to move this connectin to a network interface g 1/0/24. See g 0/0 config below:Cisco 3650 IOS 16.9.4!interface GigabitEt...
Hello, I was quoted and received a Cisco IE 3000 and needed to added a PoE module. The Power supply that came with it is a AC in/DC out. I am concerned because the DC output on the Power Supply reads 54 V ---1.2A, but the Input DC on the PoE module s...
This is happening on 3650 switches with IOS 16.9.2. I get the error, but the switch still boots fine. Any suggestions? %BOOT-3-SYSD_STARTFAIL: R0/0: Failed to launch boot task boothelper_autoup grade.service ( exit-code ) Thanks in Advance
Joe,
Were you able to resolve your issue that generated the logs? I am starting to get the same. Switch is stable and functioning.
Jan 16 01:32:31.199: %IOSXE-4-PLATFORM: Switch 1 R0/0: kernel: oobhal: 00 00 18 00 00 00 00 00 00 00 00 00 00 00 00 00...
Thank you all for the help. Since we are running fairly old Supervisor modules, the recommended commands will not work, as the files are Read Only. I opened a case with Cisco TAC and the had the solution:
SW1#erase /all non-default
Take in to acc...
