04-12-2011 11:33 PM
I installed CWLMS 4.0.1 on a Solaris 10 server. I noticed that the processes do not start automatically when rebooting the server. I have to start them manually. I receive a out of memory java error and a few more errors in my logs. It seems to be the most important processes that do not start as i am unable to do a discovery of the network. This is a evaluation version of LMS 4.0.1. Can someone please assist?
04-13-2011 10:44 PM
1. Post the daemon.log from CSCOpx/log directory.
2. How much swap space do you have for this sever?
3. Post the prtconf and prtdiag outputs.
04-14-2011 01:14 AM
04-16-2011 12:19 AM
Try increasing the heap size from /opt/CSCOpx/MDc/tomcat/webapps/rme/WEB-INF/classes/com/cisco/nm/rmeng/cli/framework/heap.properties. Increase VM_HEAP_MAX from 512 to 1024.
04-19-2011 04:19 AM
I edited the file as requested but the services still do not start utomatically after a reboot.
04-23-2011 12:21 AM
Sorry for the late response. Open a TAC SR and refer to this forum so we can webex into the server for further assistances.
04-25-2011 03:50 AM
Will i be able to do open a TAC even though the software downloaded is a trail version?
Will it be possible for some assistance with opening the TAC?
Where do i go on Cisco web etc.
04-26-2011 05:47 AM
Just for the first level analysis...Make sure the below
CW Process order:
>> The only services that should be automatic are :
* Ciscoworks Daemon Manager
* CWCS rsh/rcp
* CWCS syslog
* CWCS tftp
put the rest back to manual.
Then restart the Daemon Manager
~rate if helpful.
04-26-2011 10:43 AM
Since this is Solaris, post the install logs from /var/tmp and the files should start with CiscoWorks_Install_xxxxx.log. Did the services start up fine prior to applying the LMS 4.0.1 meaning did it work with LMS 4.0 clean install?
05-04-2011 01:05 AM
05-04-2011 04:05 AM
I installed LMS on a Solaris server.
I was not aware that you can alter the services to be manual or automatic on Solaris.
Where can i chanes these settings?
05-04-2011 10:52 AM
You have a bad installation according to the install logs, please re-install LMS after increasing swap space and disk space.
1. You don't have enough disk space.
2. Various issues with the databases attempting to change the password.
3. Missing xalan.jar and xerces.jar.
4. SWAP space is insufficient.
Please refer to the LMS Solaris installation guide for the exact steps.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: