Hello,
I have a question concerning Cisco Prime 3.1.
I have add 5 devices through SNMPv2:
- 1 *VSS 4506.
- 4 * 2960X.
After the discovery, I can see a lot of information: Hostname, uptime, version, SN, interface, interface VLAN...
But I have 2 problems:
- When I want to see graph concerning CPU and Memory, there is "no data avalaible"
- Unter DEVICE/INTERFACE/ETHERCHANNEL, when I look to an etherchannel, i can't see the operation status and admin status, there is NOT_APPLICABLE (but i can see the mode).
Any one have the same issue? How can I resolve it?
Thank you.
BR
