cancel
Showing results forĀ 
Search instead forĀ 
Did you mean:Ā 
cancel
1259
Views
0
Helpful
4
Replies

Cisco Prime Infra 3.0 and NAM-3 integration

atalebzadeh
Level 1
Level 1

Hi

I have a problem with  integration NAM-2 service module and Prime Infra,

i add NAM-3 in Prime with HTTP and SNMP , but NAM-3 not show as Data Source, i also add Prime Infra in NAM-3 ,

anybody know cause of these problem?

Many Thanks 

1 Accepted Solution

Accepted Solutions

luijimen
Cisco Employee
Cisco Employee

Hi,

Have you made sure that your Prime Infrastructure server is running an Assurance type license?

The NAM monitoring/NetFlow depend on this being enabled.

Luis

View solution in original post

4 Replies 4

luijimen
Cisco Employee
Cisco Employee

Hi,

Have you made sure that your Prime Infrastructure server is running an Assurance type license?

The NAM monitoring/NetFlow depend on this being enabled.

Luis

Yes i have Assurance License on Prime and i can receive data from WLC NetFlow .

do you have any idea?

Thanks 

Thanks.

I was able to add a NAM module and vNAM to Prime Infrastructure 3.0 by making sure to provide credentials for:

SNMP, Telnet/SSH and HTTP/HTTPS

Make sure that PI can verify all of them, some traffic might be blocked along the way.

Luis

Hi Luis

when I verify credential, every things is ok! and NAM add succesfully to Prime but not show on Data source list and not show in Assurance Monitoring as Data Source

Thanks

Review Cisco Networking for a $25 gift card