I tried to fight with google's but can't resolve a problem.
I've got Cisco swirch with IOS 15.0(2)SE4 and configured a few ports as Cisco Access Point smartports. AP's connected to that ports works only with that setting. Case is that I even can't ping AP's under its IP address. If I change the setting i.e. to Desktop I can work with AP but there is no internet connection on WiFi
Please help... I would like to monitor AP's with SNMP.
My target is to connect with Cisco Access Points with appropriate smartports settings.
As an addition. It's my port conf:
switchport trunk encapsulation dot1q
switchport trunk native vlan 2
switchport mode trunk
srr-queue bandwidth share 1 30 35 5
mls qos trust cos
macro description cisco-wireless
auto qos trust
spanning-tree bpduguard enable
There is only one in-house expert in regards to EEM. He's not there for your Beck and call. You need to be patient or you can contact TAC (your case will still go to him).