Ciscoworks - RME 4.3.1 Sotfware distribution needs 32MB minimum in Flash

[jjiles]

Hello,

I’m having the need to upgrade over one hundred Cat2900 to a newer image. When I run the software distribution application on Ciscoworks (RME 4.3.1) I get the “catastrophic” warning described below. The new image is only 7MB and there are 22MB free in flash. Is there any way to by-pass this requirement checking???

Catastrophic - SWIM1200: Selected Flash partition requires minimum (32 MB) to upgrade selected software/image. Select a different Flash partition for upgrading the image.

test3#show flash:

Directory of flash:/

   2 -rwx         616   Mar 1 1993 00:00:28 +00:00 vlan.dat

   3 -rwx       2861   Mar 1 1993 00:04:24 +00:00 config.text

   4 -rwx           5   Mar 1 1993 00:04:24 +00:00 private-config.text

   5 drwx         512   Mar 1 1993 00:10:44 +00:00  c2960-lanbase-mz.122-35.SE                   5

27998208 bytes total (22688768 bytes free)

-rwx------+ 1 Administrators None 7075041 2011-06-30 13:17 c2960-lanbasek9-mz.12

2-44.SE6.bin

[AFROJ AHMAD · Accepted solution]

Hi,

Try the below steps and I hope this should work:
1- Go to RME > Software Management > Software Repository

2 - Select the image you are trying to push (Click on the file name)

3- Change the Minimum RAM to a lower value than the RAM you have on the
device

4 - Click on Update

5 - Try the SWIM job again

Thanks
Afroj