I still don't know how to make CatOS 7.3 send coldStart and warmStart SNMP traps, after reading this doc.
http://www.cisco.com/en/US/tech/tk648/tk362/technologies_configuration_example09186a0080094aa1.shtml
I saw a warmStart in "show log" on the switch but no SNMP trap was sent, and neither was the syslog message received on the syslog server.
syslog.conf
local7.info /var/log/local7info.log
local6.info /var/log/local6info.log
local5.warn /var/log/local5warn.log
local0.info /var/log/local0info.log
local2.info /var/log/local2info.log
switch config
set snmp rmon enable
set snmp trap enable module
set snmp trap enable chassis
set snmp trap enable bridge
set snmp trap enable repeater
set snmp trap enable vtp
set snmp trap enable auth
set logging console disable
set logging server enable
set logging server 10.26.100.2
set logging level cdp 5 default
set logging level earl 5 default
set logging level fddi 5 default
set logging level ip 4 default
set logging level pruning 5 default
set logging level snmp 5 default
set logging level spantree 5 default
set logging level sys 6 default
set logging level tac 5 default
set logging level tcp 5 default
set logging level telnet 5 default
set logging level tftp 5 default
set logging level vtp 5 default
set logging level vmps 5 default
set logging level kernel 4 default
set logging level filesys 5 default
set logging level drip 5 default
set logging level protfilt 5 default
set logging level security 5 default
set logging level radius 5 default
set logging level udld 5 default
set logging level gvrp 5 default
