EEM using syslog on Nexus

[ambi]

Is the syslog as an EEM event supported in Nexus

I am trying to run an EEM applet based on a syslog but unable to.

What i want is to shutdown a particular module when a power supply on the 7K is switched off .. possible?

Ambi

[Thomas Masters]

Check this out, looks like a pretty good doc with ideas for EEM on the 7k and it has a method to pattern match syslog

http://www.cisco.com/en/US/docs/switches/datacenter/sw/5_x/nx-os/system_management/configuration/guide/sm_eem_events_and_examples.html#wp1024660

[ambi]

For some reason i am not able to get syslog as an option under event .. the only option i get is sysmgr

Any feature to be enabled before that ??

Ambi

[Thomas Masters]

Looks like it was new to NX-OS 5.1 software

http://www.cisco.com/en/US/prod/collateral/switches/ps9441/ps9402/product_bulletin_c25-617240_ps9402_Products_Bulletin.html

So you may need to upgrade.