ERSPAN (Catalyst 3650 Switches)

[cecilmayy]

IOS XE Gibraltar 16.12.x (Catalyst 3650 Switches) support ERSPAN.
Can I send ERSPAN destination to a local RSPAN vlan on the destination switch. The command are available but I could not find any documentation to support the theory.

CORE- (config) #monitor session 66?
destination SPAN destination interface or VLAN
filter SPAN filter VLAN
source SPAN source interface, VLAN
type Type of monitor session

CORE- (config) #monitor session 66 destination?
interface SPAN destination interface
remote SPAN destination Remote

CORE- (config) #monitor session 66 destination remote?
vlan Remote SPAN destination RSPAN VLAN

CORE- (config) #monitor session 66 destination remote vlan?
<1006-4094> Remote SPAN destination extended RSPAN VLAN number
<2-1001> Remote SPAN destination RSPAN VLAN number

My idea is to create a RSPAN vlan on the destination switch and send all ERSPAN data to the RSPAN vlan and then pass the RSPAN vlan on a trunk to my virtual server.  

[pieterh]

LAN Switching Configuration Guide, Cisco IOS XE Everest 16.6 - Configuring ERSPAN [Cisco ASR 1000 Series Aggregation Services Routers] - Cisco

ERSPAN Destination Ports
A destination port is a Layer 2 or Layer 3 LAN port to which ERSPAN sends traffic for analysis.

=> no (RSPAN) VLAN mentioned here only physical ports

[pieterh]

maybe this nformation from    balaji.bandi  helps

ERSPAN run over L3 network, as long as source IP and destination IP reachable.

Source IP where you are capturing the monitor session
destination when you like to sniff the traffic or mirror the traffic

a good example here : https://mrncciew.com/2017/08/17/configuring-erspan/

you can find config example : 
https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9500/software/release/16-9/configuration_guide/nmgmt/b_169_nmgmt_9500_cg/configuring_erspan.html

[pieterh]

Source IP where you are capturing the monitor session
destination when you like to sniff the traffic or mirror the traffic

a good example here : https://mrncciew.com/2017/08/17/configuring-erspan/

you can find config example : 
https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9500/software/release/16-9/configuration_guide/nmgmt/b_169_nmgmt_9500_cg/configuring_erspan.html