08-16-2005 05:25 AM
Is there any way to configure SNMP in a Catalyst 3550 to restrict MIBs (OID) that are sent to the SNMP Manager(Server)?
The server is suposed to receiver only some informations from the switch(interface up/down, CPU, memory) and I'd like to make sure that these are the only informations that the server get from the agent(switch).
Thanks in advance,
Marcelle.
Solved! Go to Solution.
08-16-2005 05:37 AM
The following link has a sample config:
http://www.cisco.com/en/US/tech/tk648/tk362/technologies_tech_note09186a00800948e6.shtml
08-16-2005 05:37 AM
The following link has a sample config:
http://www.cisco.com/en/US/tech/tk648/tk362/technologies_tech_note09186a00800948e6.shtml
08-17-2005 11:38 AM
Thanks for you answer.
The link you mentioned was good. I found the following link which added more information:
http://www.cisco.com/en/US/tech/tk648/tk362/technologies_tech_note09186a0080094489.shtml
Thanks again,
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide