cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
7847
Views
5
Helpful
17
Replies

IR809 - Upgrade

Niklas.D
Level 1
Level 1

Hi

 

So i am trying to upgrade a IR809 - firmware Version 15.7(3)M2 - and going to  ir800-universalk9-bundle.SPA.159-3.M1.bin

 

I get a timeout

 

bundle install flash:ir800-universalk9-bundle.SPA.159-3.M1.bin
Installing bundle image: /ir800-universalk9-bundle.SPA.159-3.M1.bin.......................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................
The semaphore timeout period has expired.

 

anyone seen this problem before? 

17 Replies 17

Hi Niklas, did you ever find a solution to this? I'm running into this exact issue now as well.

Niklas.D
Level 1
Level 1

Hi Yes i made a TAC case out of it. 

And you will need to make a on preem installation. 

 

You need to extract the files from "ir800-universalk9-bundle.SPA.159-3.M4.bin"  so you get this

ir800-hv.srp.SPA.3.1.21

ir800-ref-gos.img.1.14.0.6
ir800-universalk9-mz.SPA.159-3.M4
MANIFEST
ir800-universalk9-bundle.SPA.159-3.M4.bin

 

Upload them to the router.

Then change the boot

 

conf t

no boot system

boot system flash:/ir800-universalk9-mz.SPA.159-3.M4

boot system flash:/ir800-universalk9-mz.SPA.157-3.M2

 

After this you need access with console

reboot it and break it accessing rommon-1 ,crtl + c to break at boot up.

then boot with the new file

 

boot flash:ir800-hv.srp.SPA.3.1.21

(this will not install the new firmware) 

This will boot in to the new firmware, when booted in preform a install of the new firmware:

bundle install flash:ir800-universalk9-bundle.SPA.159-3.M4.bin

 

After the reload check if was a succes with 

sh platform nvram

 

Environ setting

 

-------------------------- TABLE -------------------

LICENSE_SERIAL_NUMBER=FCW223300HA

LICENSE_PRODUCT_ID=IR809G-LTE-GA-K9

CONFIG_REG=0x102

BOOT=flash:/ir800-universalk9-mz.SPA.159-3.M4,12;flash:/ir800-universalk9-mz.SPA.157-3.M2,12; <<

LICENSE_BOOT_LEVEL=

RET_2_RTS=11:36:56 CET Wed Dec 22 2021

SB_CORE_VER=F01047R15.017cc1eea2019-02-08

SB_ML_VER=MA0061R06.0404022015

 

Amazing! Thanks Niklas!

This worked for me.

Interestingly, because I initially had a successful install (but then deleted the mz.SPA file like a moron), it seems to be up on the new IOS version after the ROMMON-1> boot flash:.... command.

Review Cisco Networking for a $25 gift card