Is it possible?

[getwithrob]

The Detailed Device report will show modules that have a Major or Minor Fault.

Is it possible in RME or Campus (NOT USING DFM) to find ports that are in an errror disabled state?

[nhabib]

If you can get the switches to send syslog messages for error disabled, then you would be able to use RME.

[getwithrob]

Do you have an example of the syslog message....severity and facilty?

[nhabib · Accepted solution]

It would look something like this:

00:21:04: %PM-4-ERR_DISABLE: psecure-violation error detected on Fa0/1, putting Fa0/1 in err-disable state

[getwithrob]

Thank you.

[getwithrob]

Here's what I was able to do:

From RME > Configuration Mgmt > Network Show Commands > Batch Reports >, I was able to define a report for show port status, Schedule the Report and run the report.

This of course to find ports that went disabled before I got syslog setup and working on all devices.