02-18-2014 01:28 PM
Hi,
I am using LMS 3.2.1, and while deploying the configuration to the device via Netconfig job, I receive below error message. All commands deploy successfully but Netconfig job status always failed because of below error message;
Command(s) failed on the device TFTP: Failed on the device.
However I can sync archive the same devices successfully.
Transport Settings->Archive management = SSH TELNET TFTTP RCP
Transport Settings->Config Deployment = SSH TELNET TFTTP
Please advise how to rectify the issue.
Thanks
Solved! Go to Solution.
02-18-2014 05:02 PM
Hi Rizwan,
You are using system defiend templates to push the Netconfig job or you are using the ADHOC option ?
If you are using system defiend templates use the ADHOC job and see if it makes any difference.
I remember there were few bug on this issue ,I found one :
CSCeh40578 netconfig reports success on failure
Thanks-
Afroz
[Do rate the useful post]
****Ratings Encourages Contributors ****
02-18-2014 05:02 PM
Hi Rizwan,
You are using system defiend templates to push the Netconfig job or you are using the ADHOC option ?
If you are using system defiend templates use the ADHOC job and see if it makes any difference.
I remember there were few bug on this issue ,I found one :
CSCeh40578 netconfig reports success on failure
Thanks-
Afroz
[Do rate the useful post]
****Ratings Encourages Contributors ****
02-27-2014 02:38 AM
Thanks Afroj,
I have tried he ADHOC command and was still getting the same error, but user answer has given me confidence that its a known bug.
Also I have noticed that although I am getting the error message, its just a cosmetic message, configurations are completely implemented by the netconfig job.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide