LMS 4.0 Issues with inventory and Audit
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-10-2012 02:06 AM
Hello,
I thought that everything was running fine on our LMS 4.0 server until earlier today. Someone made a change on a switch and I wanted to see who did what.
I browsed to Audit > Change Audit, and surprise surprise, no devices are showing from the drop dow list as per the attached image.
I would like to say that all the device discovery, inventory collection, archive management, DCR Polling, and device discovery run successfully and that I don't get any errors on it.
This issue is only happening when trying to use Audit. Device management, and other features seem to properly display the device list from the All Devices Drop down list.
Is there anything that I can check to see what's causing this issue?
Many thanks,
H
- Labels:
-
Network Management
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-13-2012 02:21 AM
I think that the issue is sorted now. I remember updating the license and not rebooting the server. Devices are showing now after the reboot.
