09-26-2013 06:14 AM
Hi, We have just stood up a PI 2.0 install noticed something strange when checking the configs, In the configuration archives saw a load of devices with out of sync devices (mismatched running and start up configs.)
On checking seemed the "snmp-server location xxxx" config was missing from the running but ok in the start up.
So I tested it on a device I knew had matching start up and running and the snmp-server location in it.
Seemed that once Prime had Synced the new device the command was removed.
Anyone else come accross this "feature"?
Solved! Go to Solution.
09-26-2013 09:46 AM
We also saw this issue and was told -
as a workaround , please perform the following :
Add/sync the device with RO community (to read the system location) and after that, change the community in PI to RW with following snmp view:
snmp-server view SYS_exclude system.6.0 excluded
snmp-server view SYS_exclude iso included
snmp-server community
HTH
09-26-2013 09:46 AM
We also saw this issue and was told -
as a workaround , please perform the following :
Add/sync the device with RO community (to read the system location) and after that, change the community in PI to RW with following snmp view:
snmp-server view SYS_exclude system.6.0 excluded
snmp-server view SYS_exclude iso included
snmp-server community
HTH
09-26-2013 11:43 PM
Thanks for that!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: