Network Management

Hi,I’m currently at a loss here:In our organisation we have multiple Nexus 5000 switches, which Cisco LMS 4.2.2 cannot get the running-config and startup-config from with the Archive Management process. When it does try to get them, I get a error as ...

Is there a function within Cisco Prime Infrastructure 2.0 (2.0.0.0.294) that will display the last time that an interface was active? Our end switch hardware is as follows C2960s-48fps and C3750-48PS-S. See below for command and command output from t...

If I want to run a cnr_shadow_backup on a PNR 8.1.3, are there any cnr_shadow_backup switches/flags I have to use to run it?  I've just tried a bare cnr_shadow_backup and nothing seems to happen. Any suggestions?Eric Feldhusen

I have install LMS 4.2 and nat ip to discover found WS-6513 but cannot polling inventory.I serch for document about configuration on Network Devices such as switch, router, asa etc. to support LMS.But I cannot find it, anyone have example configurati...

Hello,I will  monitor the wireless network for a few days and just that monitor  traffic and document (utilization, who was on which AP connected ..)The wlan consists of a WLC 5508 APs and 50x 2602i.how can you find over time, how many and which wire...

Hi,is supported on C4900 EtherChannel Min-Links Feature? Or is there any alternative?I have three switches, connected in a triangle, each is connected with a second 2x10GbE in the EtherChannel.I want when one line in EtherChannel fails shutdown the e...

Hello,has anyone experience with customization of a virtual applaince as broached in the data sheet for Cisco Prime Infrastructure 2.0  on Page 5 of 7 ?...* Custom Express is not available as a separate OVA download. You will need to download the Exp...

Hello,I'm using NAM in my company to control the use of aplications in the Network, all seems to be ok but the only problem is when I want to see "host conversations" no data is collected and presented in these three fields : cnversation to .., conve...

I have a Cisco Prime Network Registrar 8.1.3 cluster all running on VMWare using the Cisco PNR 8.1.3 OVF appliances where we recently started having a problem where during the default four hour sync to the PNR Regional server, we're seeing high load ...

Hi,Is there a way to correctly display ASR9k in Cisco view? I can see a ASR9006 chassis with fans, no RSP, and Unsupportd Cards display; or ASR9001 with no PSU, and no cards.I have a following hardware config:ASR 9001NAME: "module 0/RSP0/CPU0", DESCR...