cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Ask the Expert- SD-WAN

232
Views
0
Helpful
2
Replies
Highlighted

Ping after router reloads.

Hello there, I hope you can help me with this:

I got an 819G to connect to internet via LTE, my problem is: after the router reloads, I have to send traffic via de Cellular interface, making me to log into the CLI and ping to anything in internet, this makes the cellular to get IP from the ISP and turn on the dialer interface. 

I need some Track, IPSLA or EEM to "ping 8.8.8.8 repeat 20" after the reload if the Celluar does not have IP address. 

At this moment I have an EEM to ping to 8.8.8.8 if the Cellular 0 line protocol is down. This is working fine.

Thanks.  

 

Everyone's tags (3)
1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Cisco Employee

If you have the code to ping

If you have the code to ping already, see How To Run an EEM Policy Every Time a Device Boots | EEM Scripting | Cisco Support Community on how to run an EEM policy after reload.  This policy can test to see if your cell interface has an IP, and then execute the ping if it does not.

2 REPLIES 2
Hall of Fame Cisco Employee

If you have the code to ping

If you have the code to ping already, see How To Run an EEM Policy Every Time a Device Boots | EEM Scripting | Cisco Support Community on how to run an EEM policy after reload.  This policy can test to see if your cell interface has an IP, and then execute the ping if it does not.

Thanks for your help. It is

Thanks for your help. It is working as I hoped. 

CreatePlease to create content
Content for Community-Ad
July's Community Spotlight Awards