11-12-2009 09:22 AM
I've problems with hum and cisco 6500, the interface utilization is not working except for 2 interfaces which run older systems with 10 half duplex. Everything higher is not working.
Errors:
ifHCOutOctets Gi1/1 Permanent 1 No Such Instance - The specified instance is not available Thu, Nov 12 2009, 17:42:11 CET
ifHCInOctets Gi1/1 Permanent 1 No Such Instance - The specified instance is not available Thu, Nov 12 2009, 17:42:11 CET
ifHCInOctets Gi1/10 Permanent 1 No Such Instance - The specified instance is not available Thu, Nov 12 2009, 17:42:11 CET
ifHCOutOctets Gi1/10 Permanent 1 No Such Instance - The specified instance is not available Thu, Nov 12 2009, 17:42:11 CET
ifHCInOctets Gi1/11 Permanent 1 No Such Instance - The specified instance is not available Thu, Nov 12 2009, 17:42:11 CET
ifHCOutOctets Gi1/11 Permanent 1 No Such Instance - The specified instance is not available Thu, Nov 12 2009, 17:42:11 CET
ifHCInOctets Gi1/12 Permanent 1 No Such Instance - The specified instance is not available Thu, Nov 12 2009, 17:42:11 CET
ifHCOutOctets Gi1/12 Permanent 1 No Such Instance - The specified instance is not available Thu, Nov 12 2009, 17:42:11 CET
Templates used:
Template Details
Template Name: Interface Utilization MIB2
MIB Variables: ifSpeed
ifInOctets
ifOutOctets
Template Name: Interface Utilization
MIB Variables: ifSpeed
ifInOctets
ifOutOctets
Solved! Go to Solution.
02-10-2010 09:22 AM
I was able to load this template and add it to the device that was giving me errors and remove the Interface Utilization and now I do not get the errors.
11-12-2009 09:37 AM
What version of HUM are you using? What version of code is running on this switch? Post the running config of the switch.
11-12-2009 09:46 AM
11-12-2009 09:53 AM
I see no reason why the high capacity counters would not be populated for these interfaces. Post an SNMP Walk of the ifTable and ifXTable using SNMPv2c for this device.
11-12-2009 09:55 AM
02-05-2010 12:23 PM
I got the same problem. Could you explain how you created a extra self made template?
Thanks,
Ken
02-09-2010 12:28 AM
Hello,
I think that the retry counter fixed the problem.
Try that first....
Regards,
Henk
02-09-2010 11:42 AM
Thanks for the reply. I changed the retry counter from 1 to 3 but got the same error. I got a template for monitoring interface utilization from slower speed interfaces by calling TAC per another forum discussion with same problem. Its been 4 hours and I have not recorded 1 error.
02-10-2010 12:30 AM
Hello,
Thanks for your reply.
Can you post that template overhere?
Thanks,
Henk
02-10-2010 09:22 AM
02-10-2010 11:32 PM
Thanks, I will try this one too.
Regards,
Henk
09-07-2010 05:52 AM
Would this template works for a 3750?
Thanks.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide