Has anyone else had any experience with IGMP Snooping/Querying and RedHat Enterprise Cluster?
We have been experiencing a large amount of problems with this functionality.
We are running IGMP Querying in our environment and we recently set up a second querier. Here's the steps we took Existing querier: 192.168.3.248 Everything was running fine. Added a new querier on a different switch: 192.168.3.247 At this point, all of our RedHat Enterprise Clusters fenced themselves and needed to be restarted in order to restore access. In order to restart the RedHat Enterprise Clusters, the physical servers must be rebooted. Are there any known issues with RedHat Enterprise Clustering and Cisco Switches (3750 series)? I would expect the querier change to be seamless, but it does not seem that this
is the case.
Actually - yes - we had the same problem in our Nexus environment and ultimately resolved it. Here's what you need to do:
ip igmp snooping querier x.x.x.x
no ip igmp snooping link-local-groups-suppression
I don't think the "no ip igmp snooping link-local-groups-suppression" is needed unless the multicast address is in the 184.108.40.206/24 subnet.
On newer code the snooping querier has to be configured under "vlan configuration x", not "vlan x". The querier should be the IP of the vlan interface and can be configured on multiple switches for redundancy. The lowest IP is the active one.
In our organizaiton we have Red Hat Cluster with 2 cisco switch (Model: cisco WS-C2960S-24TD-L, Version: "flash:/ c2960s-universalk9-mz.122-55.SE3/c2960s-universalk9-mz.122-55.SE3.bin").
- We are using HP Chassis c7000 and Server is on the chassis. There are 2 service IC & Med. Each server has one service primary and other secondary running.
- The two cluster switches are connected each other with Ether channer trunk (1+1) link. Also these 2 switches are connected to our Mgmt switch for Server Admin access to HP Chassis via OA port. The Red Hat system has cluster lan (pri & sec) & OA lan (01 & 02 of HP chassis) connected to Cluster switches. The Mgmt VLAN is 501 - 172.31.10.0/24.
When the CluserSW01 goes down the cluser shifted to CluseterSW02 with Cluser_Secondary_LAN and OA2. But when the Cl