A Windows 11 host 24H2 with active 802.1x on the LAN, installed VMWare Workstation and VMs that use the host LAN adapter in bridge mode responds to EAP packets from the switch that are sent to the MAC address of the VM. Why? As a result, the host its...
We have two Cisco ASA 5525 firewall at Block A and Block B where the failover was not setup yet. Should i need to configure one port at firewall and install new physical fiber cable with transceiver for peer to peer connection?
I've been looking high and low to find an answer to this question and none of the answers I have found online seem to work. I am at wits end and really need to find an answer to this question. I am using a MacBook Pro running El Captian OS X. I have ...
Hello friends,I have a couple of Cisco Nexus 9000 C93108TC-EX chassis with the following software:BIOS: version 07.69NX-OS: version 9.3(13)Last night, one of the switches rebooted by itself, and I found the following log for the incident: Nexus2# s...
loosing my tether with this, can't get a 4451 to talk to the CSLU. there's nothing special in the config, no vrfs etc, default route pointing out to the internet. There is no firewall blocking anything either. I can ping a hostname fine. SIPS#ping to...
Hello So currently I have a DSL MODEM - FPR1010 - SG350XG. My Internet is DSL w/ 8 static IP's and the FPR does the PPPoE and is connected to the SG350XG with routing back towards the Internet... On the SG350XG I have 6 vlans [each single vlan is a...
I'm building a home test lab and need the last good firmware update for SG300 switch. How can I obtain a copy?
I have a bunch of C9200 and C9300 switches. Call-Home profile is configured with "destination transport-method http". A Google search seems to indicate I should be able to change that to "destination transport-method https" but when I try to I get a ...
Hello everyone, I would like to secure my router using Netconf with an access-list. Documentation says: netconf-yang ssh {{ipv4 | ipv6 }access-list name access-list-name} | port port-number} But on my router there is no such option: router#netconf-ya...
Hello Everyone,I want to test my medical device which connects to the cloud sever through LAN and currently through our office lab network. I want to perform test by simulating the hospital network for various Downlink/Uplink speeds, latency, jitter ...
how to get the OEM letter. kindly help with this.
I'm trying to find a regular expression that works with a show command (such as show ip bgp summary) and only displays the IP addresses in the output, excluding all the other characters. I came up with the following:show ip bgp summary | include ^[0-...
Hi Team.Currently, in EPNM8.1.1 version, after configuring the EPL service for NCS5504 and ASR903 equipment, a failure occurs when looking up LSP OAM. I am wondering if this is a problem with the software XR and XE versions or if it is supported.NCS5...
Hi,I'm trying to do this exercise, i've already configured the ips , the dhcp server and the ssh to the switchI still not find the way to implement the NAT on the gateway, can someone help to configure that?I give you the exercise to help me better.T...
Dears, I have a customer who has an issue with voice between two branches; the WAN link is utilized at peak hours of the day. I need a full QOS conf end-to-end from the access switch to the WAN router Does anyone have a document ...
