cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1168
Views
5
Helpful
3
Replies

Setting the TFTP destination for RME Archive Sync

jmszkandera
Level 1
Level 1

Hi,

We are attempting to do an Archive Sync from RME in LMS 3.2.

LMS is installed on a Solaris device with multiple VNICs (let's define VNIC1 IP as 1.1.1.1 and VNIC2 IP as 10.0.0.1). The network which has managed devices on it is connected to NIC 2 in the 10.0.0.0 range. We use VNIC 1 to access LMS. There is no routing between 1.1.1.1 and 10.0.0.0.

Now, I understand that when RME attempts to sync a switch, it starts and SSH session into the device and triggers a "copy flash: tftp:" command. This is apparent from the debug logs from RME.

These TFTP based retrievals are failing because RME is setting the TFTP destination to the IP from VNIC 1 (in our case, to 1.1.1.1). Is there any way to force RME to use another IP address for the TFTP destination?

Thank you.

- JMS

1 Accepted Solution

Accepted Solutions

Martin Ermel
VIP Alumni
VIP Alumni

you should be able to workaround this by going to

     RME > Administration > System Preferences > RME Device Attribute > Add Natted RME IP Address

and enter 10.0.0.1 as the Natted IP address

View solution in original post

3 Replies 3

Martin Ermel
VIP Alumni
VIP Alumni

you should be able to workaround this by going to

     RME > Administration > System Preferences > RME Device Attribute > Add Natted RME IP Address

and enter 10.0.0.1 as the Natted IP address

Thanks very much. I'll try that and see if it works out.

Regards.

- JMS

That did the trick.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco